Skaidri sienos apsauginė danga PetWALL

Trumpai apie prekę

Prekė: Skaidri sienos apsauginė danga PetWALL. Kategorija: Guoliai ir nameliai katėms.

• Gamintojas: Mathey System
• Modelis: PetWall 40x60
• Ilgis: 59.5 cm
• Spalva: other

The PetWALL ™ wall protection mat belongs to our wide family of pet mats.

In the case of PetWALL ™, we put emphasis on protecting the wall near lairs, cages or litter boxes. Our mat is 0.25 mm thick, it is transparent and self-adhesive on the entire surface!

Thanks to the unique surface of the mat, it is very easy to remove any dirt and loose particles such as pieces of wet gravel or liquid residues.

The transparency of the mat makes it compatible with all wall colors and accessories for pets. Thanks to the fact that we do not introduce foreign elements - other colors, our transparent mat does not change the habits of pets!

Quick assembly - the mat is ready for use immediately after application.

Assembly instructions and notes:

1. We measure the width and length of the wall at the place of the litter boxes / lairs that we intend to secure
2. We order the original PetWALL ™ product by Mathey System to suit the dimensions
3. We throw the entire packaging into the waste paper container (100% paper&cardboard)
4. We clean the surface on which the PetWALL ™ will be mounted with a dry cloth, remove irregularities or fine dust (the wall should also be primed before painting)
5. We install PetWALL ™ on the protected surface as shown in the photo from left to right (or vice versa). Preferably above the skirting board at an equal distance from the floor. Align with your hand, a soft cloth or a rubber squeegee. One of our pressure rollers, available as an additional accessory, is also useful. Due to its elastic properties, the mat can also be folded up in internal corners (where litter boxes are often placed)
6. The fender can be cut with an ordinary wallpaper knife, but its surface is quite hard, so we recommend caution
7. We enjoy the advantages of PetWALL ™

! The effect is largely dependent on the quality of the wall finish, careful preparation (smoothing the surface, priming, cleanliness of the surface) and the gluing itself. Air voids that may appear depend on the unevenness of the wall and the type of paint used on the wall. In most cases, the fender can be easily removed without leaving any traces of the adhesive layer. Less adhesion or detachment of individual parts of the paint by the fender adhesive layer may occur more often (due to the inconsistency of the wall substrate itself). It is recommended to perform an adhesive test on a small invisible wall surface. Migration of adhesive particles to the wall surface takes a minimum of 24 hours, we recommend waiting a few days before fully loading the fender.

ATTENTION! Only original PetWALL ™ mats by Mathey System are a guarantee of the highest quality!

Original PetWALL ™ mats feature:

• always a special protective margin around the appropriate fender during transport !!!
• 0.25 mm thick technical transparent laminate
• rounded edges, thanks to which the fender is much more permanently attached to the walls than with sharp corners
• dedicated technical support at every stage, supported by many years of experience
• a solution tested by breeders of cats and dogs

Specifications