Pneumatinis keltuvas CHANNEL LIFT 5 t AUTOMET

Trumpai apie prekę

Prekė: Pneumatinis keltuvas CHANNEL LIFT 5 t AUTOMET. Kategorija: Pneumatiniai keltuvai.

• Gamintojas: no brand
• Modelis: PK50p

The PK-50p duct lift is designed for partial lifting of the vehicle on the workshop channel for inspection and repair work.

.

characteristic:

• Rollers

• Maximum lifting capacity 5 t

• Lifting height (extension of piston rod) 500 mm

• Rubber cap for actuator Ø 100 mm

• Hydraulic-pneumatic pump:

manual drive

pneumatic drive (air pressure 6 – 8 bar)

(both systems are independent)

• The lift is adapted to the width of the channel (channel of any length)

.

Each lift has stepless adjustment to accurately fit the channel.

The actuator is mounted in a lowered position – it is flush with the floor, on request it can be mounted in a standard position – it protrudes about 50 mm (for a typical channel edge).

The user can change the height of the actuator himself – just unscrew 4 M16 nuts, flip the small trolley over and screw the nuts back on (photo 2).

Aspen brackets (in 4 corners) protrude about 10 - 20 mm above the floor.

Each actuator is checked on the press for power, pressure retention and leaks.

.

The lifter has:

• Health and Safety Instructions (to hang on the wall)

• Declaration of conformity for the CE mark

• guarantee card

• instruction manual

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

The lift is painted in blue or red.

.

Producer:

AUTOMET

____________________________________________________________________________________________________

WHEN BUYING, PLEASE PROVIDE (picture next to it):

channel dimensions (without slack):

• L1 - width at the periphery (channel cover)

• L - width below the periphery (between walls)

• S - internal width of the angle (a lift rides on it)

• H - inner height of the angle

• blue or red.

For a different edging than the angle, please inform about it in order to select the appropriate rollers and adjust them to the lift path (a sketch of the channel may be needed).

***

Actuator mounted in the lowered version (upper photo) and in the standard version (lower photo) - higher level about 50 mm.

Simply unscrew the nuts, turn the small trolley (black) on the actuator upside down and screw it back on.

Specifications