Automobilio kabelių instaliacijos testeris, trumpųjų jungimų ir laido vientisumo matuoklis

Trumpai apie prekę

Prekė: Automobilio kabelių instaliacijos testeris, trumpųjų jungimų ir laido vientisumo matuoklis. Kategorija: Diagnostikos testeriai ir sąsajos.

• Gamintojas: no brand
• Modelis: 6932586020193

Quick and easy short-circuit locating

Evaluate continuity or wires.

Track or wires and diagnose breakpoint

Receive tone signal on or wires (phone line)

Identify the status of a working phone line (clear, caller, busy)

Send a single continuous tone or double alternating tone to or wires of the object.

Product specification

• Power supply: two 9 V batteries (brak)
• Product Width:4 cm
• Item Height: 15 inches
• Supply Voltage: 12-24V
• Operating temperature: 50°C
• Item Type:Electrical Tests and Measuring Wires
• Item length:17 cm
• Special features: short search engine

About the subject

This device is designed to identify and track wires or without damaging the insulation. You can also use it to check if there is a short circuit and open circuit movement and so on. The instrument has a sender and receiver.

Specification

1. wire tracking
2. Short-circuit checking
3. locating the open circuit
4. Identification of the cable

Function

• Wire tracking is possible even inside bundles, wires, behind panels, under carpets, upholstery, etc.
• Easy to use: Simply connect the transmitter in series with the circuit or cable being tested (i.e. in place of a burnt fuse, through a connector, in series with an open wire, bulb socket, etc. ), and scanning the circuit/wire with a flexible tracking probe to find the problematic spot
• 42 V Ready: for use in the new generation of vehicles with mixed or single 42 V systems
• Operates on DC voltages from 6 to 42 volts
• Internally protected against surges and overloads
• Flexible 7" probe allows you to reach wires in crowded places
• Transmitter and receiver LEDs show open or short-circuit status
• Adjustable sensitivity for all tracking situations
• No wire piercing required, touchless technology!

How to use the probe?

The receiver probe is constructed of steel coil and can be bent as needed to reach wires in high-traffic areas. Depending on the circuit characteristics and sensitivity settings, the probe will receive the signal from the wire in different positions. However, for the best possible range, the receiver probe tip (cap) should be positioned perpendicularly (at an angle of 90o) to the tracked wire and above or below it.

Specifications